-
A roll of insulation is not the part that an assembler installs. Before it reaches the equipment, the material may be unrolled, nested, cut, stacked, transferred and fitted around openings or fixing points. For an OEM buyer, the useful question is whether the selected mat can move through that sequence and still meet the drawing. Specify stitch-bonded fiberglass needle mat by its fiber grade, rein...
read more
-
Knitted fiberglass gasket tape is worth evaluating when an equipment seal needs a soft, conformable strip. Woven fiberglass tape is an alternative where a firmer, more dimensionally restrained textile suits the joint. Neither construction is automatically the better seal. Compare the contact it makes under the available closing load, not just its softness in the hand. Both constructions are used i...
read more
-
The flexible connections around an induction furnace need their own protection plan. A water-cooled power lead, a separate cooling-water hose and a hydraulic line can run through the same area while performing very different jobs. Their outside diameters may look similar, but their electrical, cooling and mechanical requirements are not interchangeable. Fire sleeve for induction melting provides a...
read more
-
A fiberglass braided hose sleeve can look simple on a quotation: choose a diameter, choose a length and slide it over the hose. In production, however, the braid geometry matters. As a tubular braid expands to pass over a larger hose, bend or fitting, its installed length and surface coverage can change. For OEM purchasing, fiberglass braided sleeving should therefore be specified by the finished ...
read more
français
Deutsch
русский
italiano
español
português
Nederlands
العربية
日本語
한국의
Türkçe
Polski
Tiếng Việt
slovenský
Indonesia
