-
A hydraulic hose is already connected, routed through the machine and held in position. The next maintenance review identifies a section that needs additional abrasion protection. Sliding a tubular sleeve over that assembly may require access that the installation does not provide. A wrap-around nylon hose sleeve is a removable textile cover that opens along its length and closes around an accessi...
read more
-
A custom insulation blanket can only fit as well as the information used to make its pattern. Overall length and diameter are a useful starting point, but they do not show valve stems, flanges, support brackets, cable entries, drain points or the space available for opening the cover. This guide explains how to collect practical measurements for a removable insulation blanket, which photographs to...
read more
-
A fire sleeve can fit the hose and still fail to pass over its end fitting. It can also pass over the fitting but sit too loosely along the hose. These are separate checks, and a useful fire sleeve size chart needs to address both. Select the sleeve inside diameter from the actual outside diameter of the hose, tube or finished cable bundle. Then check the largest fitting or connector the sleeve mu...
read more
-
Silicone coated fiberglass fabric for removable insulation jackets is used as a flexible outer cover around the insulation core. It provides a coated surface for handling and environmental exposure, while the insulation inside the jacket performs a different job: limiting heat transfer from the equipment. Choosing that outer fabric takes more than matching a color or thickness. A valve cover opene...
read more
-
On an existing hose assembly, both end fittings may already be connected, the route may pass behind equipment, and access may be limited to a short exposed section. In that situation, the first fire sleeve question is not the nominal diameter. It is whether a tubular sleeve has a practical installation path. A removable fire sleeve opens lengthwise so it can be wrapped around the hose instead of b...
read more
-
Fabric expansion joints for fans and blowers connect the equipment to adjoining ductwork while accommodating specified movement and providing the required gas seal. Their flexible construction can reduce the transmission of mechanical vibration through the duct connection. However, the inlet and outlet must be assessed separately: matching a fan flange is only one part of selecting the joint. BSTF...
read more
-
Ordering a custom exhaust insulation sleeve involves more than selecting a fiberglass material and giving an approximate pipe diameter. The sleeve has to fit the actual exhaust line, cover the correct heated section and remain practical to install around connections, bends and nearby equipment. For heater manufacturers, marine equipment suppliers, vehicle builders and replacement-part distributors...
read more
-
The flexible connections around an induction furnace need their own protection plan. A water-cooled power lead, a separate cooling-water hose and a hydraulic line can run through the same area while performing very different jobs. Their outside diameters may look similar, but their electrical, cooling and mechanical requirements are not interchangeable. Fire sleeve for induction melting provides a...
read more
-
A fiberglass braided hose sleeve can look simple on a quotation: choose a diameter, choose a length and slide it over the hose. In production, however, the braid geometry matters. As a tubular braid expands to pass over a larger hose, bend or fitting, its installed length and surface coverage can change. For OEM purchasing, fiberglass braided sleeving should therefore be specified by the finished ...
read more