-
A high temperature welding blanket should not be selected from a single maximum-temperature number. Two blankets may both be described as suitable for high-temperature service while behaving very differently under welding sparks, molten spatter, radiant heat or prolonged contact with a hot component. The base fiber, coating, fabric weight, thickness, blanket orientation and duration of exposure al...
read more
-
Carbon Fiber Braided Sleeve Sizing and Installation Guide A braided sleeve does not have one fixed diameter. Push the ends toward each other and the tube opens; pull them apart and it becomes narrower. The length changes at the same time. That is why a sleeve that slips easily over the widest part of a mandrel may cover less of the part than its cut length suggests. Start with the part drawing, th...
read more
-
3K vs 6K vs 12K Carbon Fiber Braided Sleeves: Tow Size and Product Selection A buyer asks for a 3K carbon fiber sleeve. The next question should be: for what installed diameter? The K designation describes the nominal filament count in a carbon tow; it does not specify a finished sleeve diameter, thickness or the strength of a cured tube. Those depend on the whole braid construction and the lamina...
read more
-
Ordering a custom exhaust insulation sleeve involves more than selecting a fiberglass material and giving an approximate pipe diameter. The sleeve has to fit the actual exhaust line, cover the correct heated section and remain practical to install around connections, bends and nearby equipment. For heater manufacturers, marine equipment suppliers, vehicle builders and replacement-part distributors...
read more
-
A fiberglass braided hose sleeve can look simple on a quotation: choose a diameter, choose a length and slide it over the hose. In production, however, the braid geometry matters. As a tubular braid expands to pass over a larger hose, bend or fitting, its installed length and surface coverage can change. For OEM purchasing, fiberglass braided sleeving should therefore be specified by the finished ...
read more
-
A sleeve that fits a wire on the bench may be difficult to install after the terminal has been crimped. It may also sit next to a motor winding, a hot appliance part or a sharp metal edge. Those details affect the sleeve you order. For electrical wiring, the useful starting point is the finished assembly and its working conditions, rather than a diameter and a temperature number alone. BSTFLEX's H...
read more